HIRO Build Guides
HIRO 180 Center Stack
 The basic component stack using a 4-in-1 ESC and 3D printed cam mount |
|---|
 The hardware and parts needed. |
 place the 4-in-1 on top of (4) 6mm 3M male |
 Trim (2) 6mm 3M male by two threads |
 Install the trimmed male on rear of stack |
 Install (2) 6mm 3M female on front of stack |
 Place FC on stack |
 place (2) 10mm 3M female on back of stack |
 Use (2) 6mm 3M bolts to secure cam mount on rear. Use (2) more 6mm 3M bolts to secure front of cam mount |
 200mm battery strap |
 Thread strap through slits. Place (4) 6MM 3M bolts up through bottom HIRO plate |
 Secure the (4) bolts to the 3M females on bottom of component stack |
 The HIRO top pod should fit without issue. |
