HIRO Build Guides

HIRO 180 Center Stack

The basic component stack using a 4-in-1 ESC and 3D printed cam mount
The hardware and parts needed.
place the 4-in-1 on top of (4) 6mm 3M male
Trim (2) 6mm 3M male by two threads
Install the trimmed male on rear of stack
Install (2) 6mm 3M female on front of stack
Place FC on stack
place (2) 10mm 3M female on back of stack
Use (2) 6mm 3M bolts to secure cam mount on rear. Use (2) more 6mm 3M bolts to secure front of cam mount
200mm battery strap
Thread strap through slits. Place (4) 6MM 3M bolts up through bottom HIRO plate
Secure the (4) bolts to the 3M females on bottom of component stack
The HIRO top pod should fit without issue.